Posted by rgthompson on April 11, 2017 at 07:26:11 from (107.77.70.95):
In Reply to: Clean terminals? posted by showcrop on April 11, 2017 at 04:12:49:
I wish I had read this before I posted a question this morning! I have a similar problem but since the battery is brand new, I assumed the terminals were fine. That was a mistake, I see now. I have not looked at the connections on the starter yet but will now go check tonight. I'll take what you said and go check it all out and it sounds like the problem will be easy to correct. Thanks!
FYI -!Here's what I originally posted:
I have a 1949 Farmall H that is having trouble starting. It responds very sluggishly and only turns over a rotation of two at a time. It will eventually start after I have pushed and held the switch maybe twenty times. The switch (and cables to it) become almost too hot to touch before it will start and they will actually smoke if I try too many times. Once it starts, the switch and wires cools down. Although I am planning to switch it over soon to 12 volt, it is still a 6 volt system with the positive ground. The battery is brand new also. I am looking for any suggestions or was wondering if anyone else has had this problem before. Perhaps a bad ground? Or am I losing voltage across a bad starter? Any thoughts would be appreciated! Thanks.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - Tractor Hydraulics - The Basics - by Curtis Von Fange. Hydraulics was one of the greatest inventions for helping man compound the work he can do. It’s amazing how a little floor jack can lift tons and tons of weight with just the flick of a handle. What’s even more amazing is that all the principals of hydraulic theory can be wrapped up in such a small package. This same package applies to any hydraulic system from the largest bulldozer to the oldest and smallest tractor. This short series will take a look at the basic layout of a simple hydraul
... [Read Article]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.
