Posted by george md on May 04, 2017 at 21:58:02 from (209.213.167.201):
In Reply to: Patching cast iron posted by kickinbull on May 04, 2017 at 06:21:45:
KB, Question, before answering,is the crack in a curved area or is it in a flat area ? If it is an ear or curve , you might get away with a form of arc weld . If it is in a flat area , leave the arc weld idea on the shelf . Do the oven method , Use a pile of fire brick , build a box to fit the work. Heat slowly with large propane torch (weed burner etc) heat to 1200 weld ,when done heat to 1500 and hold temp for 15 to20 minutes, cooling time from 1500 to 1000 must not be less than 30 minutes and slow cool to cold , in oven with cover that time will be about 12 hours.
If you understand cast iron ,you will know why arc weld is usually a failure . It does not matter how cool you keep the work while welding , the arc makes extreme heat and when that puddle cools , the material around the puddle contracts and being cast is not ductile something has to happen,either the weld bead splits up the middle or the bead pulls away from the base material (crack).
Here are a couple photos of cast that all the arc weld ideas go out the window.
george
manifold is very thin , need to replace much of the thin area
sections replaced and ex flange made and installed
Upload one or more videos to your post. Photo filesizes should be less than 300K and Videos, less than 2MB. Formats allowed are gif, jpg, png, ogg, mp4, mov, and avi. Be sure to use filenames without spaces or special characters, and filetypes of 3 digits lower case.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - Usin Your Implements: Bucket Loader - by Curtis Von Fange. Introduction: Dad was raised during the depression years of the thirties. As a kid he worked part time on a farm in Kansas doing many of the manual chores. Some of the more successful farmers of that day had a new time saving device called a tractor. It increased the farm productivity and, in general, made life easier because more work could be done with this 'mechanical beast'. My dad dreamed that some day he would have his own tractor with every implement he could get. When he rea
... [Read Article]
Latest Ad:
Sell 1958 Hi-Altitude Massey Fergerson tractor, original condition. three point hitch pto engine, Runs well, photos available upon request
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.
