Posted by Pete Black on May 07, 2017 at 07:08:56 from (107.77.90.16):
In Reply to: 6 volt system posted by BMLutra on May 07, 2017 at 05:06:54:
Here's my take; the battery has two primary purposes on initial startup, to provide reserve cranking power and provide voltage for ignition spark. Once the engine is running then the generator' s purpose is to recharge the battery and run the auxiliaries on the tractor, therefore, dependent upon battery state of discharge the amp meter should show a substantial positive amp flow. As battery charge is increased then the amp meter indication should decrease and continue to until the battery is fully charged. At this point the battery remains in standby power and the generator provides the power for the auxiliaries, which on a 6 volt system, other than providing ignition, is very limited and typically is lighting. Therefore once battery is fully charged then the generator ampere output is quite small unless the auxiliaries need is more than the generator can produce at which point the battery then contributes to carry the additional load. After auxiliary load is removed then the generator recharges the battery to a fully charged condition. This is why you see varing charging rates. As Bob stated 30 amp meter versus 60 amp meter will show a substantial difference in amp meter hand position only due to its calibration.
Upload one or more videos to your post. Photo filesizes should be less than 300K and Videos, less than 2MB. Formats allowed are gif, jpg, png, ogg, mp4, mov, and avi. Be sure to use filenames without spaces or special characters, and filetypes of 3 digits lower case.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - Tractor Hydraulics - The Basics - by Curtis Von Fange. Hydraulics was one of the greatest inventions for helping man compound the work he can do. It’s amazing how a little floor jack can lift tons and tons of weight with just the flick of a handle. What’s even more amazing is that all the principals of hydraulic theory can be wrapped up in such a small package. This same package applies to any hydraulic system from the largest bulldozer to the oldest and smallest tractor. This short series will take a look at the basic layout of a simple hydraul
... [Read Article]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.
