I thought someone with actual experience with this pump would have an answer, and you might get a better answer on the Ford board below, but here is my generic guess...
Somewhere there is a pressure relief valve. It could be behind the fitting where the pressure line connects, or could be under a plug somewhere on the pump. There will be a spring holding the relief valve plunger against it's seat.
"If" the replacement pump is identical to, or closely resembles the old pump, you will simply swap the spring from the old pump to the new. You should see a difference in the springs. The old spring will be weaker, allowing for a lower pressure regulation.
But, there is a possibility the pressure could be set with shims. If that is the case, replace the spring and shims from the old pump.
And, it could be an adjustable setting. If that is the case, it would need to be set with a pressure gauge after it is installed.
Again, hopefully someone that has actually done it will offer their solution, there are just some guesses as to what to look for and how hydraulic pressures are typically set.
Upload one or more videos to your post. Photo filesizes should be less than 300K and Videos, less than 2MB. Formats allowed are gif, jpg, png, ogg, mp4, mov, and avi. Be sure to use filenames without spaces or special characters, and filetypes of 3 digits lower case.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - Tractor Hydraulics - The Basics - by Curtis Von Fange. Hydraulics was one of the greatest inventions for helping man compound the work he can do. It’s amazing how a little floor jack can lift tons and tons of weight with just the flick of a handle. What’s even more amazing is that all the principals of hydraulic theory can be wrapped up in such a small package. This same package applies to any hydraulic system from the largest bulldozer to the oldest and smallest tractor. This short series will take a look at the basic layout of a simple hydraul
... [Read Article]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.
