Posted by Dave H (MI) on June 08, 2017 at 07:06:37 from (50.108.105.151):
In Reply to: hay hay anfd hay posted by bg/mo on June 07, 2017 at 10:51:14:
I had to repair the baler from when it broke down last year. 2016 was a really hard year here and when it broke after 50 bales I called a guy up and gave him the hay if he would bale it. I kept 100 bales to keep around for the kids goats. I had enough of farming by mid June last year and almost quit entirely. So this year I had the rest of the place planted early so I pulled up the baler and I think I have it repaired. I cut a couple acres yesterday to test it on later this week. Hopefully we are back up and running. Hay gives me a little operating $$$$ during the summer to tide me over until fall. Otherwise I have to borrow from the business that pays the other bills...and I rather not.
Never really gave it a lot of thought but it is kind of cool how quickly I move this stuff in and out of the shop these days. Usually stays fixed too! Learned a lot here over the years! :)
Upload one or more videos to your post. Photo filesizes should be less than 300K and Videos, less than 2MB. Formats allowed are gif, jpg, png, ogg, mp4, mov, and avi. Be sure to use filenames without spaces or special characters, and filetypes of 3 digits lower case.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - Third Brush Generators - by Chris Pratt. While I love straightening sheet metal, cleaning, and painting old tractors, I use every excuse to avoid working on the on the electrics. I find the whole process sheer mystery. I have picked up and attempted to read every auto and farm electrics book with no improvement in the situation. They all seem to start with a chapter entitled "Theory of Electricity". After a few paragraphs I usually close the book and go back to banging out dents. A good friend and I were recently discussing our tractor electrical systems when he stated "I figure it all comes back to applying Ohms Law". At this point
... [Read Article]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.
