For that, you'd have to ask the folks that initiated the standards to begin with. As mentioned in the other thread, when I first got into construction, the primary measurements were 1.75" x 3.75" for 2x4. I suppose to stop the confusion and bickering, they finally took all things into account and made the standard as 1.5" x 3.5" for 2x4's, knowing that some sawmills would be able to cut smaller than 2x4 rough due to the thin kerf of band mills. I haven't looked at any of this in decades, but last I saw, there was nothing stating that the boards had to be exactly 1.5" x 3.5", and I'm betting there still isn't. Meaning, if you get a board that is 1.75" x 3.75", that it would still be considered OK. Again, I don't know. Has been over 20 years since I learned this stuff.
Just as building code is "minimum acceptable standard", dimensioned lumber sizes are also (again, to the best of my outdated knowledge) "minimum acceptable standard". In other words, you can have lumber measuring somewhat greater than 1.5" or 3.5" (for 2x4), but not less than. Anything less would be too weak for properly getting an acceptable strength rating. Full 2" x 4" would be considered rough cut, and would almost certainly have no way of getting graded for or as construction-grade (referring to the Amish here).
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - Madison's County - by Anthony West. Philip Madison has been a good friend of mine for quite some time. He has patiently suffered my incessant chit chat on the subject of tractors for longer than I care to remember, and on many occasions he has put himself out, dropped what ever it was he was doing, to come and lend a hand cranking handles, or loading a find onto a trailer. Although he himself has never actually owned or restored a tractor, he was always enthusiastic and always around helping with other peoples projects.
... [Read Article]
Latest Ad:
1953 Ford Jubilee Tractor. Last driven 5 yrs ago. Parked ever since. As is as seen
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.