Posted by big roller on June 25, 2017 at 16:00:53 from (96.44.122.78):
I have an Oliver 1855 with MFD. I want to work out the correct calculations for the % lead/ lag.
Here are the numbers for mine
When one side of the tractor is raised with the mfd engaged: The driveshaft turns close to 29.50 times for 2 turns of the rear tire and 20 turns for 2 turns of the front tire (by the way the tag was wrong). I could be off slightly if slack between gear teeth can make a difference.
When the rear tire is turned once, the front tire turns 1.4706 times (once around plus 8 of 17 tire lugs). Or inversely 0.68 measured the other way.
Currently the front tires are BKT 14.9x25 with manufacturer RCI of 152.1 The rears are Goodyear 18.4x38 with a listed RCI of 207. These are the tire sizes suggested in the operators manual for this tractor. Unfortunately there were different ratios used and the manual does not specify which ratio their recommendations are for.
There seem to be different opinions on how to calculate the lead. By what I read the desired lead is 2 to 6%. To me it seems higher here. I have posted before but never really got a complete answer. Some good replies on this would be so helpful. It would also be nice to hear more comments from guys familiar with these tractors as well.
Upload one or more videos to your post. Photo filesizes should be less than 300K and Videos, less than 2MB. Formats allowed are gif, jpg, png, ogg, mp4, mov, and avi. Be sure to use filenames without spaces or special characters, and filetypes of 3 digits lower case.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - Tractor Hydraulics - The Basics - by Curtis Von Fange. Hydraulics was one of the greatest inventions for helping man compound the work he can do. It’s amazing how a little floor jack can lift tons and tons of weight with just the flick of a handle. What’s even more amazing is that all the principals of hydraulic theory can be wrapped up in such a small package. This same package applies to any hydraulic system from the largest bulldozer to the oldest and smallest tractor. This short series will take a look at the basic layout of a simple hydraul
... [Read Article]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.
