Thanks for the feedback. Being its a diesel instead of a gas engine the wiring methods used to provide initial excitation voltage to the alternators small side 1/R terminal can vary a lot and still work, but its not rocket science and perhaps ? its wired to work already ONCE YOU SWAP THE TERMINALS on that white plastic connector ? I have seen oil pressure switches or various other switches and methods used on diesels to send excitation voltage down to 1/R on the alternators side. Can your white plastic connector be changed side to side so wiring is reversed and still plug in or not????? I've seen plastic tabs that prevent reversal while I've also seen some (maybe jury rigged??) that can be reversed. Most guys just jump the small 2/F terminal to the big main rear output on the alternator and it works fine. As a used tractor dealer I've seen hundreds working okay wired that way while the actual battery voltage on the terminal could be slightly different and wiring instead to the battery could be better. Either way will work.
I didn't take time to go look at a 10SI Alternator to see FOR SURE what side is 1/R and what side is 2/F and NOTE my and others explanations are assuming its wired wrong YOU HAVE TO LOOK AT YOUR ALTERNATOR TO MAKE SURE and if its NOT as were thinking we all have to go back to the drawing board lol ITS THE 2/F TERMINAL THAT SENSES VOLTAGE AND IS WIRED TO THE BIG MAIN REAR OUTPUT STUD OR BATTERY
Upload one or more videos to your post. Photo filesizes should be less than 300K and Videos, less than 2MB. Formats allowed are gif, jpg, png, ogg, mp4, mov, and avi. Be sure to use filenames without spaces or special characters, and filetypes of 3 digits lower case.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - An Old-Time Tractor Demonstration - by Kim Pratt. Sam was born in rural Kansas in 1926. His dad was a hard-working farmer and the children worked hard everyday to help ends meet. In the rural area he grew up in, the highlight of the week was Saturday when many people took a break from their work to go to town. It was on one such Saturday in the early 1940's when Sam was 16 years old that he ended up in Dennison, Kansas to watch a demonstration of a new tractor being put on by a local dealer. It was an Allis-Chalmers tractor dealership,
... [Read Article]
Latest Ad:
Sell 1958 Hi-Altitude Massey Fergerson tractor, original condition. three point hitch pto engine, Runs well, photos available upon request
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.