Posted by chevytaHOE5674 on July 08, 2017 at 06:20:03 from (216.129.151.153):
In Reply to: 99 ford F250 ? posted by hydro70guy on July 07, 2017 at 12:47:58:
Good chance the spindle bearing in the back of the wheel unit bearing is bad allowing the axle shafts to "flop" around and halfway engage in the hub and viberate, often times it starts when hitting bumps in the road. If locking the hubs makes it go away then 9/10 that's your problem. If your lucky the axle shaft bearing race isn't chewed up and you can replace just the spindle bearings for like 9 bucks a side, unlucky your outer stub axle and U-joints will need replacing as well.
Reach inside the steering knuckle and lift up on the axle shaft. If you can move it a bit up and down and watch it move in the backside of the wheel bearing then you have a problem, it should be fairly tight.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - Tractor Profile: Allis-Chalmers Model G - by Staff. The first Allis-Chalmers Model G was produced in 1948 in Gasden, Alabama, and was designed for vegetable gardeners, small farms and landscape businesses. It is a small compact tractor that came with a complete line of implements especially tailored for its unique design. It featured a rear-mounted Continental N62 four-cylinder engine with a 2-3/8 x 3-1/2 inch bore and stroke. The rear-mounted engine provided traction for the rear wheels while at the same time gave the tractor operator a gre
... [Read Article]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.
