Hi I have Michelin agribibs on my Valtra, one of those was doing similar in the side walls. it had fluid in so it was a pain by the 3rd time we took it off after the tire shop did it the first time. They put the cheap made in China plastic tube in that lasted a month before getting a hole in and you could see other places it was near through the other times we mended it !.
What we did with that in the end was put an expensive thick rubber tube in it, then looked real careful inside the tire for any signs of more places that would give trouble soon. Once you knew what to look for it was easy to find them. I was going to use small tire boots on those spots to, but our local guy said thats to expensive.
He recommended some rectangular patches maybe 2" wide and maybe 4 1/2" long to stick over the new forming bad area's just to stop them rubbing the tube. That tire lasted 2 years like that on our main loader tractor with no further problems. I had an opportunity to get rid of that tire and rim for a good matched one as a straight swap, when my friend put flotations on his tractor so i got rid of the bad one.
Yeah technically the tire guy might be right and what I did depends on how bad the cracks are, mine was 1/4 to 1/2" long at the most. I probably had $60 in patches. $180 in the tube, but way over 2" of lug left on tires that are probably 1500-$2000 + each for good radials to replace them. If I did the backs the fronts needed changing to as it's front assist so i'd a probably been in at $6000 pretty quick. Maybe you can replace yours for a sensible price and just be done with the messing around. Regards Robert
Upload one or more videos to your post. Photo filesizes should be less than 300K and Videos, less than 2MB. Formats allowed are gif, jpg, png, ogg, mp4, mov, and avi. Be sure to use filenames without spaces or special characters, and filetypes of 3 digits lower case.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - Harvestin Hay: The Early Years (Part 2) - by Pat Browning. The summer of 1950 was the start of a new era in farming for our family. I was thirteen, and Kathy (my oldest sister) was seven. At this age, I believed tractor farming was the only way, hot stuff -- and given a chance I probably would have used the tractor, Dad's first, a 1936 Model "A" John Deere, to go bring in the cows! And I think Dad was ready for some automation too. And so it was that we acquired a good, used J. I. Case, wire tie hay baler. In addition to a person to drive th
... [Read Article]
Latest Ad:
Sell 1958 Hi-Altitude Massey Fergerson tractor, original condition. three point hitch pto engine, Runs well, photos available upon request
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.
