The JD 48 loader was the earlier model JD loader made to the middle to big row crop tractors. It only had a single bucket cylinder mounted in the middle of the bucket. This really limited the roll back force. It also made that mid mount be a weak link in on the loader. You see the majority of them with the bucket cylinder mount broke all to heck.
The JD 148 loader replaced the JD 48 loader. The main improvement was twin bucket cylinders. The JD 148 loader was built for close to 15 years. This became the loader of choice on the JD 3020 and JD 4020.
I do not see why you think you need axle brackets on a JD 148 loader that is going on a Waterloo built tractor. If you have the mounting bracket bolted on correctly with the mid support in place you will break the loader in two pieces before you break anything on the tractor behind the clutch housing. Now if your putting a JD 148 loader on a JD Mannheim built tractors like a JD 2840 or 2940 then you would need some axle supports. They do not have full frame rails.
Now for your first question. A JD 148 loader will bolt right on your JD 2510. You have plenty of loader for that tractor. I have mounted JD 146 loaders on JD 2520 and that was a better fit. The trouble is there where many fewer JD 146s loader built than the JD 148 loader.
So forget the darn axle brackets. You see them on the after market loaders because they did not have strong enough mounts to handle the stress without the axle brackets.
Upload one or more videos to your post. Photo filesizes should be less than 300K and Videos, less than 2MB. Formats allowed are gif, jpg, png, ogg, mp4, mov, and avi. Be sure to use filenames without spaces or special characters, and filetypes of 3 digits lower case.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - A Brief History of Tractors in Australia - by Bob Kavanagh. After Captain Cook's exploration of the east coast in 1770 the British Government decided to establish a penal colony in Australia. The first fleet arrived in 1788 and consisted mainly of convicts who were poorly equipped and new little of farming techniques. The colony remained far from self-supporting and it was not until the early 1800's that things started to improve. Free settlers started to arrive, they followed the explorers across the mountains and where land was suitable set up farms. T
... [Read Article]
Latest Ad:
Sell 1958 Hi-Altitude Massey Fergerson tractor, original condition. three point hitch pto engine, Runs well, photos available upon request
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.