Why swap out the bad rear end with another worn-out differential? You will not find a good junk yard rear end, as they tend to go at around 100K. My guess is that one has already been rebuilt at least once.
I assume "going out" means the bearings are getting loose, causing the rear end to make noise and leak oil. And if they haven't already been replaced, the ring and pinion gears are likely gone. Minimal rebuild will require a bearing kit which runs about $150. For less than 500 bucks, you can buy the parts for a full rebuild: bearing kit, ring and pinion set and wheel bearings. Add another 500 bucks and you can upgrade to a TruTrac locking differential (assuming it doesn't already have a locker). I've done a rebuild myself, I won't say it was easy but it wasn't terribly difficult; you need a dial indicator to set up the backlash. Or, for about 500 bucks labour you can have a rear end shop do the whole job.
I doubt it has a 4.10 rear end. I'm not sure what was offered in '95, but I think 3.48 or 3.73 is more likely.
Upload one or more videos to your post. Photo filesizes should be less than 300K and Videos, less than 2MB. Formats allowed are gif, jpg, png, ogg, mp4, mov, and avi. Be sure to use filenames without spaces or special characters, and filetypes of 3 digits lower case.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - Usin Your Implements: Bucket Loader - by Curtis Von Fange. Introduction: Dad was raised during the depression years of the thirties. As a kid he worked part time on a farm in Kansas doing many of the manual chores. Some of the more successful farmers of that day had a new time saving device called a tractor. It increased the farm productivity and, in general, made life easier because more work could be done with this 'mechanical beast'. My dad dreamed that some day he would have his own tractor with every implement he could get. When he rea
... [Read Article]
Latest Ad:
Sell 1958 Hi-Altitude Massey Fergerson tractor, original condition. three point hitch pto engine, Runs well, photos available upon request
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.