I was just a maintenance weldor, but in my limited experience I felt I could get better "puddle control" and better looking welds using DC reverse polarity, if DC reverse rod was available and suitable. But I found AC or DC straight polarity may give better penetration sometimes and start a little easier. In our shop we had an old Hobart MG set welder that would help you lay really pretty welds using D.C. Reverse rod, but for "quickie" jobs out in the production and furnace areas we often just used a Lincoln 225 AC buzz box and never switched leads to get DC. In DC mode the electrons run from the stinger to the workpieces one way, in straight polarity from the workpieces to the stinger in reverse polarity......With AC the electrons (or current flow) run both ways....That's how it was explained to me anyway. Our fancy TIG welder had a low voltage AC auxiliary mode to help start while using DC reverse mode to make the ball on the electrode off a stainless blank for aluminum welding and straight polarity for the actual welding of the aluminum or while using a parallel ground pointed electrode doing ferrous metals (steel and iron alloys). IIRC.
Upload one or more videos to your post. Photo filesizes should be less than 300K and Videos, less than 2MB. Formats allowed are gif, jpg, png, ogg, mp4, mov, and avi. Be sure to use filenames without spaces or special characters, and filetypes of 3 digits lower case.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - A Farmall Story - by Ed Meadors. The year was 1978. Our young family had recently moved to rural Chesapeake, Virginia to a plot of land which would finally allow us to realize our dreams of a huge garden, critters and more lawn and pasture than we would ever use! We needed a TRACTOR; not a riding mower or tractor wannabe, but a real TRACTOR. The answer to our needs materialized in the form of a '44 Farmall A, complete with cultivators, discs, single plow, a 5ft.Woods belly mower and one, mounted spare 9.00x24 rear wheel.
... [Read Article]
Latest Ad:
Sell 1958 Hi-Altitude Massey Fergerson tractor, original condition. three point hitch pto engine, Runs well, photos available upon request
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.