No, you were right the first time. 60Hz 'switches direction' 120 per second. The first quarter phase is up, then from the + peak to the - peak(2nd and 3rd quarter phase) it is going down(1st change), then from the - peak back to 0deg it is again going up. Or, if started from 90deg at plus peak, one could say it crosses the zero phase line twice.
As for the welder, if it's hot, you may be just overheating it. Most big sparky welders have a large fan, make sure that's turning. There should be vents in the case, and make sure they are not covered or clogged.
All old sparky welders have a 'duty cycle'. The duty cycle decreases with rise in amps. That means you can weld for x seconds, then idle for y seconds. If you are using a high amp load this could be the duty cycle limitation, although that would be typically affecting both AC and DC.
Smell the unit right as it stops putting out current, tell me if you smell hot lacquer, or a burning plastic kind of smell. That would be a breakdown of the transformer wire shellac (junk if so).
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - The Nuts and Bolts of Fasteners - Part 2 - by Curtis Von Fange. In our previous article we discussed capscrews, bolts, and nuts along with their relative hardness and thread sizes. In this segment we will finish up on our fasteners and then work with ways to keep them from loosening up in the field. Capscrews, bolts and nuts are not the only means of holding two parts together. When dealing with thinner metals like sheet tin, a long bolt and
... [Read Article]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.
