Well the baler is a Claus baler built for Gehl. It is just a bunch of drums with shafts sticking out the sides driven by chains. The bale pressure is made by the bale forcing the door open against the hydraulic cylinders. Simple and will bale anything you can get thro0ugh the pickup. The only thing Gehl on that baler is paint and decals. They where sold as MF and OMC too. The main parts are just sprockets and chains. Nothing special. The pickup teeth are easy to match at about any tractor supply place. Actually being a Gehl, OMC, or MF makes the parts easier. The drum shafts are turned down to the next smaller US size rather than metric. When I had my Claus baler it had metric bearings and back in the 1980s they were not easy to find.
As for the soft core. They will squat some but if you learn how to run them they will make a pretty good bale. The ley to making a good solid bale is when the bale gets about full slow your ground speed down and let the bale turn longer in the chamber under pressure. That will make the outside rock hard and it will shed water great.
I had several Claus Round balers. Bought two new ones just for the mesh wrap feature. Never owned a JD round baler until a JD 566.
So for just a few bales of grass type hay they can't be beat for the money you can buy them for. They do take more Horse power to pull/turn the baler when they are full of hay. I ran mine with a 100 HP tractor and had now issues but a 75 HP tractor would have it's hands full. I would buy a Drum baler any day over an old NH chain baler. Just many fewer moving parts.
James Howell has a drum baler he pulls with his Two bangers.
Upload one or more videos to your post. Photo filesizes should be less than 300K and Videos, less than 2MB. Formats allowed are gif, jpg, png, ogg, mp4, mov, and avi. Be sure to use filenames without spaces or special characters, and filetypes of 3 digits lower case.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - Earthmaster Project Progress Just a little update on my Earthmaster......it's back from the dead! I pulled the head, and soaked the stuck valves with mystery oil overnight, re-installed the head, and bingo, the compression returned. But alas, my carb foiled me again, it would fire a second then flood out. After numerous dead ends for a replacement carb, I went to work fixing mine.I soldered new floats on the float arm, they came from an old motorcycle carb, replaced the packing on the throttle shaft with o-rings, cut new ga
... [Read Article]
Latest Ad:
Nice Marvel Schebler DLTX 8 bronze body carburetor For 1934-1936 unstyled A tractor.Serial No.410000-42850. All restored and ready to use.
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.