Posted by jimb2 on August 22, 2017 at 13:50:55 from (99.251.163.226):
In Reply to: Re: 454 transmission posted by txpoweranger on August 21, 2017 at 19:02:32:
Hi, as the other Jim says if the spring is broken it is causes the throwout bearing to always contact the pressure plate fingers. Eventually the throwout bearing seizes and wares the fingers off the pressure plate and eventually someday you go to step on the clutch to stop the tractor and the clutch doesn't release.
If you have no free play that probably indicates the clutch pads are worn. On the 54/74/84/85/95 series tractors as the clutch pads ware the clutch pedal free play decreases. Try adjusting the clutch pedal. There is an inspection plate that can be removed on the bottom of the clutch housing but really can't see much other than throwout bearing and pressure plate. The springs also get weak on the pressure plate. Very easy tractor to do a clutch replacement if there is no front end loader. Replace, pilot and throwout bearings, clutch with 6 pad clutch and pressure plate.
Upload one or more videos to your post. Photo filesizes should be less than 300K and Videos, less than 2MB. Formats allowed are gif, jpg, png, ogg, mp4, mov, and avi. Be sure to use filenames without spaces or special characters, and filetypes of 3 digits lower case.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - Tractor Hydraulics - The Basics - by Curtis Von Fange. Hydraulics was one of the greatest inventions for helping man compound the work he can do. It’s amazing how a little floor jack can lift tons and tons of weight with just the flick of a handle. What’s even more amazing is that all the principals of hydraulic theory can be wrapped up in such a small package. This same package applies to any hydraulic system from the largest bulldozer to the oldest and smallest tractor. This short series will take a look at the basic layout of a simple hydraul
... [Read Article]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.
