Posted by fixerupper on September 11, 2017 at 13:03:31 from (174.219.4.132):
In Reply to: Sand Blasting.....? posted by banjoman09 on September 11, 2017 at 08:36:42:
A sand blaster works great on wheels and the frame too if it's a bare frame with no delicate parts attached. One thing everyone who has a sandblaster should do is take a scrap piece of light tin, hit it with the sand blaster and watch the tin warp. Then you will know what could happen to the light sheet metal parts of whatever you are sand blasting.
Old is right about the water problem. If you sand blast for a long period of time you will want to drain the compressor tank regularly unless you are in a dry climate like Arizona. Water coming through the air line will plug up the works when it hits the sand. Once you have your hot protective garb on you won't be happy about disrobing so you can unscrew clean out plugs to remove the wet sand. And finally , never under estimate sand's ability to get into everything.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - Third Brush Generators - by Chris Pratt. While I love straightening sheet metal, cleaning, and painting old tractors, I use every excuse to avoid working on the on the electrics. I find the whole process sheer mystery. I have picked up and attempted to read every auto and farm electrics book with no improvement in the situation. They all seem to start with a chapter entitled "Theory of Electricity". After a few paragraphs I usually close the book and go back to banging out dents. A good friend and I were recently discussing our tractor electrical systems when he stated "I figure it all comes back to applying Ohms Law". At this point
... [Read Article]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.
