Posted by John T on September 20, 2017 at 10:33:37 from (216.249.81.101):
In Reply to: 6 volt change to 12v posted by craig45 on September 20, 2017 at 09:46:54:
Craig, good question "do I need a new coil or just a resistor"
ANSWER : You can EITHER use the existing 6 volt coil but add ahead in series between the IGN switch and the coils input a discrete bathtub style voltage dropping (12 down to 6, many in the 1.2 to near 2 or so ohms resistance) ballast resistor, that's the cheapest method ORRRRRRRRRRRRRRRRR you can get a new full true 12 volt rated coil (NO ballast required) many typical old farm tractor 12 volt coils have somewhere around 2.5 to 3.5 LV primary ohms as measured between the 2 small + and - terminals.
NOTE since this is an old tractor forum NOT an old car forum, I'm talkin "typical" old farm tractor coils NOT old American car or truck coils, some of which used 6 volt others used 12 volt, and some had different resistances then above and also different ballast resistances to match the particular coil and ballast together.
NOTE most all typical old farm tractor coils DO NOTTTTTTTTTTTT have an internal stand alone discrete ballast resistor tucked away and hidden inside the can, even though some refer to them as having an internal ballast. Typical old farm tractor 6 volt coils have around 1.2 to under 2 ohms LV primary resistance while a typical old farm tractor 12 volt coil will have more like 2.5 to under 4 ohms.
Wire whichever coil to match the tractors polarity
NAPA or O Reillys or Tractor Supply or Rural King etc etc stock BOTH 6 and 12 volt rated coils
Upload one or more videos to your post. Photo filesizes should be less than 300K and Videos, less than 2MB. Formats allowed are gif, jpg, png, ogg, mp4, mov, and avi. Be sure to use filenames without spaces or special characters, and filetypes of 3 digits lower case.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - A City Guy's First Tractor - by Fred Hambrecht. After living in apartments in Atlanta for more years than I care to remember, the wife and I decided to move to the country. Humming "Green Acres is the place for me..." we purchased a 29 acre tract about 60 miles south of Atlanta. Next came the house, I could talk about that ordeal for another two weeks... But, I want to talk about my tractor! We didn't even own a lawnmower, and all of a sudden we had enough grass to feed all the starving children of the bovine world. Naturally, I talked
... [Read Article]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.
