Posted by David in Wi on October 16, 2017 at 17:32:24 from (216.127.198.150):
In Reply to: Chevy truck problems posted by Jon f mn on October 16, 2017 at 09:10:28:
Jon, Hi I work for a GM dealer. Your son's problems. We do see some problems with the tie rods. Not a lot. The question would be have then been greased properly. Some forget to grease them on a oil change. Some over grease them damaging the boots. Water gets in and damages them. Hubs bearings we do not see a lot. If you replace them make sure you get the best you can buy. We find the less expensive ones only last about 6 mouths. The oil usage. Yes we do have problems. They us low tension rings. 6.0L we don't do a lot. The fix is to replace the rings. You can try cleaning. Seefom or trans fluid in the oil for about 500 miles. Then change oil. The oil rings get stuck and fill with gunk. If you want you could e-mail me the last 8 of the vin. and I could get a copy of the warranty hist. for you if want. David
Upload one or more videos to your post. Photo filesizes should be less than 300K and Videos, less than 2MB. Formats allowed are gif, jpg, png, ogg, mp4, mov, and avi. Be sure to use filenames without spaces or special characters, and filetypes of 3 digits lower case.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - Harvestin Hay: The Early Years (Part 2) - by Pat Browning. The summer of 1950 was the start of a new era in farming for our family. I was thirteen, and Kathy (my oldest sister) was seven. At this age, I believed tractor farming was the only way, hot stuff -- and given a chance I probably would have used the tractor, Dad's first, a 1936 Model "A" John Deere, to go bring in the cows! And I think Dad was ready for some automation too. And so it was that we acquired a good, used J. I. Case, wire tie hay baler. In addition to a person to drive th
... [Read Article]
Latest Ad:
Sell 1958 Hi-Altitude Massey Fergerson tractor, original condition. three point hitch pto engine, Runs well, photos available upon request
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.