Posted by fixerupper on October 16, 2017 at 19:59:55 from (174.219.133.197):
In Reply to: Corn Crib Question posted by Kerwin on October 16, 2017 at 18:31:25:
The bucket elevator dropped the corn in a spout or funnel, if you want to call it that in the middle of the crib, then it slid down an extendable chute that could be rotated any direction. Usually the chute had three extensions that slid inside each other to telescope, sometimes four if it was a long crib. The chutes were usually half chutes with an open top. When the chute was extended all the way the angle flattened and sometimes damp shucky corn didn't want to slide well. That's when we got out the car wax.
The elevator could have been a bucket elevator in the fancier cribs. If there was no inside elevator an outside elevator was stuck through a door in the side of the cupola. A lot of times the elevator stayed there year round because it was quite a job backing the elevator through that little door way up there with the elevator swaying side to side. And the elevator was hand cranked to raise it. The arms and stamina were tested by the time the elevator was at full height. I can still remember the whomp, whomp, whomp sound of the corn coming out of the buckets or elevator flights and hitting the tin chute.
My job as a kid was to go upstairs in the crib when it was getting full and kick corn out into the far ends of the crib as it was coming down the chute. When I ran out of room or energy, whichever happened first, I had to be quick to get back to the cupola door to wave to the guy unloading the wagon to stop. Our 80 year old neighbor, god bless him, would be down there unloading the wagon but he never looked up to see if I was waving. I'd wave and wave, then scurry back down to the end of the spout to kick more corn so the spout that was now backed up to the top, could empty, then I'd go back to the cupola door and frantically wave again. I'd even throw ears of corn at him out of desperation. Sometimes I could get back down the ladder in time to run around the crib and stop the elevator before it plugged. Sometimes I was too late. (Sigh). Man, that was fifty years ago already. Where does the time go! I'm sure many of you midwesterners can tell the same story. LOL
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - Third Brush Generators - by Chris Pratt. While I love straightening sheet metal, cleaning, and painting old tractors, I use every excuse to avoid working on the on the electrics. I find the whole process sheer mystery. I have picked up and attempted to read every auto and farm electrics book with no improvement in the situation. They all seem to start with a chapter entitled "Theory of Electricity". After a few paragraphs I usually close the book and go back to banging out dents. A good friend and I were recently discussing our tractor electrical systems when he stated "I figure it all comes back to applying Ohms Law". At this point
... [Read Article]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.
