They do have integral valve guides (cast into the head), there is a lot of material around them so they can be reamed oversize. The valve seats have inserts that can be changed, I can find them for the intake, but not for the exhaust. Diesels usually use Tungsten Carbide material for the valve seats, the longer it gets run the harder the valve seat gets, and it makes them last even longer.
I'm currently rebuilding the head now on my 1971 4500 with the 201 diesel, the valve guides are worn some . It's cheaper to just ream the valve guides oversize, and replace them with valves with oversize stems. With valve guide inserts you have to ream the guides bigger, press the new guides in, then ream the new guide to the right diameter. The valve seats just need to be cut a little bit to make sure the surface of the 45 degree angle is flat so the valves will have a good seat to seal properly.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - The Niagra View Mobile - Powered by a 1959 Ford Tractor - by Mark Massey. In 1959 the Niagara Frontier Transit Inc. of Buffalo, New York designed and built six Viewmobiles for the Niagara Frontier Sightseeing Inc. for use as a sightseeing ride at the Niagara Falls State Park, Niagara Falls, New York, powered by a 1959 Ford 611 Tractor.
... [Read Article]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.
