I have no problem with China as a parts source. The only problem I have is the US purchasing agents that write the specs for the parts that China produces, usually for the cheapest price possible.
Case in point on the spec. being the factor here: Bearings for my JD round baler rollers. Seiko (the Japanese watch maker), is into the bearing business. They do the specs and China does the work. Guarantee you that you put one of those suckers in your hand and it never held a more quality product.
Something else about the oriental mind. Think back when they hit the American automotive market. Think about what Detroit offered us for transportation. Think about what was standard equipment from Detroit (had a 1965 Ford F100 that didn't even have a HEATER) and what MAY have been available as an added accessory. Think about how the oriental mind came with everything as standard equipment. My wife worked with them in semiconductor assembly. Engineers would come over from Japan. No rock was left unturned. Minute details are of the essence. Apparently it's a way of life for them.
Case in point. WM usually has a carton of cheap flash lights sitting around the auto/sporting goods sections. 2 bucks for an LED driven by a couple of AA batteries. Super light, super price. Sure beats the bulb with 2 D cells we used to have to buy. But here's the kicker. The plastic case, like plastic cases on US made flashlights, has a flat side on it so that when you lay it down, it won't roll around...........never saw a US flashlight with such. The detailing just goes on and on.
Sorry for you nay sayers, but "diversity" IS good for us!
Upload one or more videos to your post. Photo filesizes should be less than 300K and Videos, less than 2MB. Formats allowed are gif, jpg, png, ogg, mp4, mov, and avi. Be sure to use filenames without spaces or special characters, and filetypes of 3 digits lower case.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - Museum Coverage: The Stuttgart Agricultural Museum - by Cindy Ladage. While cold wind was blowing back in Illinois, in Arkansas, daffodils were in bloom, and the Magnolia trees were adorned with fragrant blossoms. Stuttgart, Arkansas was the site of this year's winter Minneapolis Moline Collector's show February 25-27, 1999. The show was held at the Oliver Museum created by Don Oliver, the pioneer of the four wheel drive tractor. Oliver along with Gale Stroh and Kenneth Bull using Minneapolis Moline tractors and parts created what has become known as
... [Read Article]
Latest Ad:
Sell 1958 Hi-Altitude Massey Fergerson tractor, original condition. three point hitch pto engine, Runs well, photos available upon request
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.
