Posted by Duane WI on November 10, 2017 at 09:07:58 from (69.29.248.14):
In Reply to: Dairy production posted by jacksun65 on November 10, 2017 at 07:56:07:
I do large project engineering for food companies. I am not involved with the projects noted in the original post but currently involved with similar projects with other companies. The food processing industry is going through a wave of consolidation and improving efficiency. In short they are building new plants to be able to shutdown old plants. The new plants are more highly automated and streamlined. The old plants are just getting too old and inefficient. A lot of the current food processing facilities where built in the 1960s and 1970s. They need to keep them running to meet current consumer demand but everything needs to be updated. It is cheaper to build a new plant and shutdown the old plant. Trying to make large updates to an existing plant and keep it in operation is just really difficult. This also gives them the ability to negotiate with local governments to get economic incentives to build the new plant in their town.
Upload one or more videos to your post. Photo filesizes should be less than 300K and Videos, less than 2MB. Formats allowed are gif, jpg, png, ogg, mp4, mov, and avi. Be sure to use filenames without spaces or special characters, and filetypes of 3 digits lower case.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - Third Brush Generators - by Chris Pratt. While I love straightening sheet metal, cleaning, and painting old tractors, I use every excuse to avoid working on the on the electrics. I find the whole process sheer mystery. I have picked up and attempted to read every auto and farm electrics book with no improvement in the situation. They all seem to start with a chapter entitled "Theory of Electricity". After a few paragraphs I usually close the book and go back to banging out dents. A good friend and I were recently discussing our tractor electrical systems when he stated "I figure it all comes back to applying Ohms Law". At this point
... [Read Article]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.
