Posted by flying belgian on November 21, 2017 at 10:11:40 from (216.114.240.149):
In Reply to: Re: Ford Tractor posted by oldtanker on November 21, 2017 at 07:25:30:
I don't see how some of you guys get by without tipping your lawn mower over. My lawn mower is very high and narrow and tippy yet I have never tipped it over. You just kinda have a natural "feel" for when it is getting to steep. The same feel when walking through a road ditch. Instinct tells you're body how far to lean forward when walking up a ditch bank. You do it without even thinking. I have that same feel when farming on a steep hillside. I instinctively know my limit. I thought everyone did. That being said, folklore in the neighborhood has it that two young brothers were curious how fast they could drive the car around a tight curve in the road. So they went five mph faster each time. Rolled the car at 45 mph. Conclusion was you have to go less then 45.
Upload one or more videos to your post. Photo filesizes should be less than 300K and Videos, less than 2MB. Formats allowed are gif, jpg, png, ogg, mp4, mov, and avi. Be sure to use filenames without spaces or special characters, and filetypes of 3 digits lower case.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - The Nuts and Bolts of Fasteners - Part 2 - by Curtis Von Fange. In our previous article we discussed capscrews, bolts, and nuts along with their relative hardness and thread sizes. In this segment we will finish up on our fasteners and then work with ways to keep them from loosening up in the field. Capscrews, bolts and nuts are not the only means of holding two parts together. When dealing with thinner metals like sheet tin, a long bolt and
... [Read Article]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.
