Very accurate. I put in a swimming pool about 10 years ago. I did the design, and hired the subs. There are three inspections due for in-ground pools in my area. I called after the dig and with the steel in, and waited most of the day for the guy to show up. He drove up in an old truck, shuffled out, at about 350Lbs, wandered over near the hole, and filled out a small green tag. He couldn't even bend down to put the tag on the rebar. The second time he didn't even show. The third time just before adding water I came by and we chatted for a bit. He asked me to go take a picture of the pool and equipment and bring it back to the truck. I had a couple pics on the phone, and he signed the final and handed it to me. 'Have a good one!' and he was off. Total cost - $477. gah, what a tool.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - The Nuts and Bolts of Fasteners - Part 2 - by Curtis Von Fange. In our previous article we discussed capscrews, bolts, and nuts along with their relative hardness and thread sizes. In this segment we will finish up on our fasteners and then work with ways to keep them from loosening up in the field. Capscrews, bolts and nuts are not the only means of holding two parts together. When dealing with thinner metals like sheet tin, a long bolt and
... [Read Article]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.
