Posted by JD Seller on December 21, 2017 at 11:15:51 from (208.126.197.230):
In Reply to: If all goes well posted by larry@stinescorner on December 21, 2017 at 06:28:21:
Larry I would build a building with the center tall enough for your tractors and such. SO you would be 24 foot wide by 32 foot long and 12 foot to the square. This way you can put in a 10 foot tall 12 foot wide over head garage door. I would concrete all of this area. Then I would put lean to sheds on each side. Keep the same roof pitch as the main section but only make them 8 foot deep with the open side 8 foot tall. Just gravel the sheds.
So you can back in the side sheds and store your three point implements. Then use the center for your two tractors and a shop/work area.
This would give you plenty of room for your stuff while the implements would be easy to get to. Then down the road if you sell the place the center section would be just about the size of a two car garage. SO the value of the shed would not detract non farm buyers.
I am think on this same issue where I currently live, If I build the shop like I am used to then it would make selling the property down the road harder. The 40 foot by 80 foot 18 foot tall shop I want would not be of much use to the average person that would buy a 4 acre property. So the shop would lose a lot of "value" because of the limited number of buyers down the road. So I am leaning towards a smaller shop. If I need to work on larger stuff I can go to the farm.
Upload one or more videos to your post. Photo filesizes should be less than 300K and Videos, less than 2MB. Formats allowed are gif, jpg, png, ogg, mp4, mov, and avi. Be sure to use filenames without spaces or special characters, and filetypes of 3 digits lower case.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - George's Fordson Major - by Anthony West (UK). This is a bit of a technical info to add on to the article about George's Major in the "A Towny Goes Plowing" article. George bought his Major from a an implement sale about 18 years ago for £200.00. There is no known history regarding its origins or what service it had done, but the following work was undertaken by Harold alone to bring it up to show standard. From the engine number, it was found that the major was produced late 19
... [Read Article]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.
