> here was never an actual "surplus". Revenue exceeded spending for a very short time, but scheduled spending increases would have wiped that out regardless of who was President, especially after 9/11.
Bret, the point isn't whether or not Dollar Bill handed Junior a surplus. It's how Junior, starting out with a budget that was more-or-less balanced, deliberately ran it into the red. The interesting thing is that Dubya could have maintained a balanced budget if he had either backed out the tax cuts or opted not to invade Iraq. (A country, you will recall, that had absolutely nothing to do with 9/11.) It was the one-two punch of tax cuts and wars that blew out the deficit. Now, when Junior decided to invade Iraq, he could have said, "Ya know, everybody will have to suffer a bit so we can make Iraq safe for Islamist militants. So I'm asking Congress to roll back our tax cuts so we can pay for this little adventure." Instead, every year he presented a "balanced budget" to Congress that explicitly excluded the wars in Iraq and Afghanistan so he could PRETEND to have a balanced budget while actually borrowing money to fund the wars.
Upload one or more videos to your post. Photo filesizes should be less than 300K and Videos, less than 2MB. Formats allowed are gif, jpg, png, ogg, mp4, mov, and avi. Be sure to use filenames without spaces or special characters, and filetypes of 3 digits lower case.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - Third Brush Generators - by Chris Pratt. While I love straightening sheet metal, cleaning, and painting old tractors, I use every excuse to avoid working on the on the electrics. I find the whole process sheer mystery. I have picked up and attempted to read every auto and farm electrics book with no improvement in the situation. They all seem to start with a chapter entitled "Theory of Electricity". After a few paragraphs I usually close the book and go back to banging out dents. A good friend and I were recently discussing our tractor electrical systems when he stated "I figure it all comes back to applying Ohms Law". At this point
... [Read Article]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.
