Posted by Cory Schmidt on January 05, 2018 at 11:10:26 from (70.40.226.124):
In Reply to: COLD Nasty day Question posted by Adirondack case guy on January 05, 2018 at 08:42:31:
we have an outdoor boiler unit, then also a small furnace in the greenhouse.
To the left of the unit is a trailer, its either switched out or filled with blocks using the loader to bring blocks over from pile. To the right is a chopper box filled with blocks. On either side are cribs that we cut full then bring over with the loader.
Here are a few loads ready to hook on and roll over to the furnace.
We skid boards ect and stack em out back till needed, then cut as needed. we also have this chopper box piled full of wood cut to around 16inch (can also see a pile of boards to be cut and a crib half full for the big burner.)
Wood is taken into the greenhouse and can be rolled to with in ten feet of the furnace with shopping carts.
Before we got the outside one, we used to have a small furnace in the house and one in the shop. The shop used the carts or wheel barrel like the greenhouse. The house we got a wheel barrel load out of the shed(building by the saw) and take it to the pile in the basement by the arm load.
Upload one or more videos to your post. Photo filesizes should be less than 300K and Videos, less than 2MB. Formats allowed are gif, jpg, png, ogg, mp4, mov, and avi. Be sure to use filenames without spaces or special characters, and filetypes of 3 digits lower case.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - An Old-Time Tractor Demonstration - by Kim Pratt. Sam was born in rural Kansas in 1926. His dad was a hard-working farmer and the children worked hard everyday to help ends meet. In the rural area he grew up in, the highlight of the week was Saturday when many people took a break from their work to go to town. It was on one such Saturday in the early 1940's when Sam was 16 years old that he ended up in Dennison, Kansas to watch a demonstration of a new tractor being put on by a local dealer. It was an Allis-Chalmers tractor dealership,
... [Read Article]
Latest Ad:
Sell 1958 Hi-Altitude Massey Fergerson tractor, original condition. three point hitch pto engine, Runs well, photos available upon request
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.