Posted by Pete in Holland MI on January 09, 2018 at 08:39:08 from (104.129.196.79):
In Reply to: New Furnace Price posted by olgentdc on January 08, 2018 at 20:12:25:
Put a new 96% Carrier natural gas furnace in the house a couple years ago. Furnace cost was around $1400. Installation parts & pieces & some sheet metal work added another $125. Rebates from the gas & electric company (DC blowers draw less electricity). Project wrapped up at just short of $800.
Being most of you guys are handy folks repairing and restoring tractors, I'm suprised more of you don't undertake this project. Furnaces are not that big of deal to install. Takes about an afternoon. A 110V line, low voltage thermostat lines, simple black iron pipe, PVC or sheet metal ducting. Pay $75 to have the furnace guy inspect it afterwards if it makes you feel better. For myself, parents, and friends, I seem to install a furnace every year or so. If you go down this path, just curl up with the instruction manual and go thru it front to back, highlighting things that pertain to your installation.
Upload one or more videos to your post. Photo filesizes should be less than 300K and Videos, less than 2MB. Formats allowed are gif, jpg, png, ogg, mp4, mov, and avi. Be sure to use filenames without spaces or special characters, and filetypes of 3 digits lower case.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - Third Brush Generators - by Chris Pratt. While I love straightening sheet metal, cleaning, and painting old tractors, I use every excuse to avoid working on the on the electrics. I find the whole process sheer mystery. I have picked up and attempted to read every auto and farm electrics book with no improvement in the situation. They all seem to start with a chapter entitled "Theory of Electricity". After a few paragraphs I usually close the book and go back to banging out dents. A good friend and I were recently discussing our tractor electrical systems when he stated "I figure it all comes back to applying Ohms Law". At this point
... [Read Article]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.
