Posted by Bob on February 14, 2018 at 08:00:23 from (64.255.159.199):
In Reply to: 6V to 12V.... posted by banjoman09 on February 13, 2018 at 15:57:17:
Quoting Removed, click Modern View to see
"Ford used a resistor to cut the 6 volt down to 4.8 volt thinking points would burn with higher voltage. "
Leroy, "VOLTS" typically don't "burn" ignition points, it's the increased CURRENT that is caused by increasing the supply voltage.
Coils are not created equal, and an OEM 2N coil has a very low primary resistance vs. many other 6 Volt coils as used in other manufacturer's products.
As to modern replacement coils for the "front-mount distributors, apparently their resistance can vary widely from one to another or to the original OEM coil.
The purpose of the ballast resistor is to add resistance to the primary circuit, limiting current through the points.
A commonly accepted primary current upper limit for long point life is about 4 Amps.
Accurately measuring the primary CURRENT is a far more accurate way of determining if more or less primary resistance is needed that an Voltage check.
Lots of anecdotal evidence about all this, such as yours, but a simple Amperage test will "tell the tale".
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - An Old-Time Tractor Demonstration - by Kim Pratt. Sam was born in rural Kansas in 1926. His dad was a hard-working farmer and the children worked hard everyday to help ends meet. In the rural area he grew up in, the highlight of the week was Saturday when many people took a break from their work to go to town. It was on one such Saturday in the early 1940's when Sam was 16 years old that he ended up in Dennison, Kansas to watch a demonstration of a new tractor being put on by a local dealer. It was an Allis-Chalmers tractor dealership,
... [Read Article]
Latest Ad:
Sell 1958 Hi-Altitude Massey Fergerson tractor, original condition. three point hitch pto engine, Runs well, photos available upon request
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.