Posted by BJ-WI on March 03, 2018 at 19:36:58 from (174.197.5.138):
In Reply to: Re: Bruce from Canada posted by Bruce from Can. on March 03, 2018 at 19:12:43:
Bruce, it should handle any height bale as long as it is 4 ft long. I make my balage 4×4 because that is all the higher my barn ceiling will allow...lol.
Green line, I have an alley at the end of the barn 8 ft wide, that's where I load the unroller. My newest, and widest barn Manger is around 6ft. Plenty wide to turn the corner. Yes, the stalls came from freudenthal. They are about a 45 minute drive from me. I had those put in in 2002-2003. Had the barn all redone over 2 years by a Mennonite crew. The stalls originally had loops that stuck out in the Manger as did the drinking cups. When I got the bale unroller 2 years ago, I had a guy come in with a big chop saw and cut the loops off and I turned the cups to be on the stall side of curb. I gained a foot in the manger. They do sell the stalls without loops, too. I would recommend them and also mounting the cups on the cow side of curb, how my barn is now. No more of cows slobering water in the manger on the feed and getting buildup.
Upload one or more videos to your post. Photo filesizes should be less than 300K and Videos, less than 2MB. Formats allowed are gif, jpg, png, ogg, mp4, mov, and avi. Be sure to use filenames without spaces or special characters, and filetypes of 3 digits lower case.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - Fabricating Sidesheets - by Chris Pratt. The easiest and best first-time project for wanna-be sheet-metal workers like myself is flat or nearly flat metal cut and drilled to be a tractor's sidesheet. A sidesheet is sheetmetal to cover either the engine as in the case of early Oliver's, Massey-Harris' and many crawlers or the wiring and electrical components as in the case of the Massey-Harris Pony, Allis Chalmers' D Series (D-14, D-15, D-12, D-10, D-17, and D-19). The need for fabricating becomes obvious when you go to buy any of these
... [Read Article]
Latest Ad:
Sell 1958 Hi-Altitude Massey Fergerson tractor, original condition. three point hitch pto engine, Runs well, photos available upon request
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.