37chief: I have to agree with you. The biggest screw up I see out of this is not shutting down traffic while they were working on the bridge.
Some things to think about: 1) The motivation for this bridge was the single death of a student. Now we have six dead because of the bridge. No point just an observation. 2) I am not any type of engineer. I just do not see any common sense in having a 1000 ton bridge to span only 175 feet. I would bet that a steel bridge could have been built that was much lighter and cheaper/faster to build. 3) I am betting that several egg heads and politicians pushed this bridge design because it was "pretty" and would be "ground breaking". All while spending other people's money, TAX payers. 4) I wonder if the same wizards of smart will try to just change the design a little bit and rebuild it like the one that failed???? 5) I bet there are prefabbed steel bridges that could be build entirely off site and trucked in within a short time frame. You not redesigning the wheel here folks. I know of several walk bridges that span much longer distances and they are simple steel structures built in sections and bolted/welded together.
Upload one or more videos to your post. Photo filesizes should be less than 300K and Videos, less than 2MB. Formats allowed are gif, jpg, png, ogg, mp4, mov, and avi. Be sure to use filenames without spaces or special characters, and filetypes of 3 digits lower case.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - Tractor Profile: Allis-Chalmers Model G - by Staff. The first Allis-Chalmers Model G was produced in 1948 in Gasden, Alabama, and was designed for vegetable gardeners, small farms and landscape businesses. It is a small compact tractor that came with a complete line of implements especially tailored for its unique design. It featured a rear-mounted Continental N62 four-cylinder engine with a 2-3/8 x 3-1/2 inch bore and stroke. The rear-mounted engine provided traction for the rear wheels while at the same time gave the tractor operator a gre
... [Read Article]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.
