Send them a letter requesting the minutes via the mail with return receipt requested, once you get the receipt back showing they have received the request staple it to a copy of the letter. This constitutes a legal request, they can't deny getting it and will make it much harder to weasel out of their inaction. I can see where they can limit you to 5 minutes speaking, but having you removed unless you were disturbing the meeting or threatening them is illegal. However it will probably be a your word against theirs, so document what you have done, make the requests in writing and use return receipt mail to eliminate the possibility of them denying receiving it. When they threatened to call the Sheriff you probably should of asked them to do so because at that point the sheriff's deputy would have to make the decision to arrest or forcibly remove you, and if they did so they would have to explain why at a later date. If they didn't have a good reason to do so then it would possibly come back on them, if you had a copy of the current statute for BOR's in you pocket showing it to the deputy may influence their decision and they may decide removing you could mean problems for them in the future. If it is an election year and the Sheriff is up for re-election and they're getting complaints the Sheriff may just pop in and set though the meeting to kind of get a feel for what's going on, if the sheriff sees wrong doing they might mention it to the D.A and the county board.
Upload one or more videos to your post. Photo filesizes should be less than 300K and Videos, less than 2MB. Formats allowed are gif, jpg, png, ogg, mp4, mov, and avi. Be sure to use filenames without spaces or special characters, and filetypes of 3 digits lower case.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - Earthmaster Project Progress Just a little update on my Earthmaster......it's back from the dead! I pulled the head, and soaked the stuck valves with mystery oil overnight, re-installed the head, and bingo, the compression returned. But alas, my carb foiled me again, it would fire a second then flood out. After numerous dead ends for a replacement carb, I went to work fixing mine.I soldered new floats on the float arm, they came from an old motorcycle carb, replaced the packing on the throttle shaft with o-rings, cut new ga
... [Read Article]
Latest Ad:
Nice Marvel Schebler DLTX 8 bronze body carburetor For 1934-1936 unstyled A tractor.Serial No.410000-42850. All restored and ready to use.
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.