Posted by gregww on March 22, 2018 at 14:04:58 from (50.82.11.92):
In Reply to: Foundation Repair posted by Hobo,NC on March 22, 2018 at 12:46:26:
I m no expert on these matters, but it seems to me the only way this can be properly fixed, is from the bottom up. Meaning down to or below frost line. I am not familiar with Ramjack. I am assuming it is a company that pumps grout under a concrete failure, to jack it back up. I have had this done to a concrete slab, and it lasted about 2 years. The slab fell again. Not as far, but it did fall. Unless Ramjack was willing to give you a lifetime warranty on their work, I would not trust this method with this amount of failure. Another thing to remember, a lot of times a warranty isn't worth the paper it's written on. It would take a reputable lawyer to decipher most written warranties today. You don't mention if you have a basement or not. Sometimes people think I am stupid for asking that question, as basements are not at all common in some parts of the country. Where I live, very few houses are built without a basement. If it has a basement, it may not be as big a job as you might suspect.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - Tractor Hydraulics - The Basics - by Curtis Von Fange. Hydraulics was one of the greatest inventions for helping man compound the work he can do. It’s amazing how a little floor jack can lift tons and tons of weight with just the flick of a handle. What’s even more amazing is that all the principals of hydraulic theory can be wrapped up in such a small package. This same package applies to any hydraulic system from the largest bulldozer to the oldest and smallest tractor. This short series will take a look at the basic layout of a simple hydraul
... [Read Article]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.
