That is quite a bit, in comparison to have run the same year in a 4000 for many years. Even my 850 ford, LP powered, would cut the 7 acre field on one 30Lb propane tank, taking 4 hours, with just a little fuel to spare. My much newer ford/nh 4630 does a lot better, won't burn 5 gallons in the same field under the same conditions.
Keep the mower adjust correctly on the tractor, blades sharp or replaced,and try to get the mowing done when the plants are still young, soft to cut, makes a huge difference in how efficient they shred through the rotary cutter. That and keeping the tractor in good tune like was mentioned.
Cutting early also avoids running in dry chaff which is miserable if I wait too long to cut around here. I like to only cut the place once per year, but have already finished all the fields and small patches and paths already to avoid ever running in those conditions again. Chaff and fuzz clogging up the radiator screen. Chaff/dust in your eyes, won't ever wait that long again, or will skip it LOL !
Upload one or more videos to your post. Photo filesizes should be less than 300K and Videos, less than 2MB. Formats allowed are gif, jpg, png, ogg, mp4, mov, and avi. Be sure to use filenames without spaces or special characters, and filetypes of 3 digits lower case.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - Usin Your Implements: Bucket Loader - by Curtis Von Fange. Introduction: Dad was raised during the depression years of the thirties. As a kid he worked part time on a farm in Kansas doing many of the manual chores. Some of the more successful farmers of that day had a new time saving device called a tractor. It increased the farm productivity and, in general, made life easier because more work could be done with this 'mechanical beast'. My dad dreamed that some day he would have his own tractor with every implement he could get. When he rea
... [Read Article]
Latest Ad:
Sell 1958 Hi-Altitude Massey Fergerson tractor, original condition. three point hitch pto engine, Runs well, photos available upon request
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.