A bit sensitive today Two Dogs. Hmmm, yes I have heard of that stuff and actually I did read it (and I did it all by myself). Here is your post again for you ....... "If it is in a flat area how about putting a patch of the same material over it with small sheet metal screws or pop rivets. Or on a leaking welder gas tank I got some kind of putty-like epoxy that you had to knead a little to mix it up and it hardened just fine and never leaked again."
I see two solutions that you present in your original post ...... the first one using just a patch of the same material as the tank is made from and attaching it with sheet metal screws or pop rivets. No mention made of JB Weld, gasket material or epoxy there. Then a second method (separated from the first fix by the word "or") which suggests a different method of repair.
I was obviously referring to your patch method #1. So it would seem that I can actually read quite well after all. I suggest you lighten up a bit.
Upload one or more videos to your post. Photo filesizes should be less than 300K and Videos, less than 2MB. Formats allowed are gif, jpg, png, ogg, mp4, mov, and avi. Be sure to use filenames without spaces or special characters, and filetypes of 3 digits lower case.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - The Nuts and Bolts of Fasteners - Part 2 - by Curtis Von Fange. In our previous article we discussed capscrews, bolts, and nuts along with their relative hardness and thread sizes. In this segment we will finish up on our fasteners and then work with ways to keep them from loosening up in the field. Capscrews, bolts and nuts are not the only means of holding two parts together. When dealing with thinner metals like sheet tin, a long bolt and
... [Read Article]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.
