Posted by robert major on June 20, 2018 at 16:45:49 from (142.160.195.10):
In Reply to: pump shop rip off posted by Al Baker(pumpman) on June 20, 2018 at 14:13:37:
That whole story sounds about right at 2 out of 3 pump shops in this area of Canada especially if you are English or other foreigner . The 3rd guy is a fellow Englishman thats been here years and has lucas CAV factory experience. If it's for an old antique or classic tractor thats not urgent he does better shop deals if you can wait.
You also get the truth on anything you take there and know the English and other stuff's right too. The others just tell you leave a blank check and we'll fill it in and cash it before you get the pump back. I told them I needed to know before or i was gonna scrap the tractor depending on cost. In the end my reply finished with something " Off" if they thought I was giving them a blank check to fill in. the 3rd guys busy I wonder why L.O.L Regards Robert
Upload one or more videos to your post. Photo filesizes should be less than 300K and Videos, less than 2MB. Formats allowed are gif, jpg, png, ogg, mp4, mov, and avi. Be sure to use filenames without spaces or special characters, and filetypes of 3 digits lower case.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - The Nuts and Bolts of Fasteners - Part 2 - by Curtis Von Fange. In our previous article we discussed capscrews, bolts, and nuts along with their relative hardness and thread sizes. In this segment we will finish up on our fasteners and then work with ways to keep them from loosening up in the field. Capscrews, bolts and nuts are not the only means of holding two parts together. When dealing with thinner metals like sheet tin, a long bolt and
... [Read Article]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.
