Ok, for all you 'experts' concern about running all the current up to the dash, into the ammeter and back to the loads, this is a fallacy. The only heavy current for the ammeter needed is the known resistance shunt bar. The tiny wires for the EMF sensing the current can be in the dash, while the shunt bar is anywhere you want.
The best setup would be the shunt bar just in front of the +batt terminal. With the key off, and circuit 30 and 15 not powered, the shunt bar would have no current flow, so no EMF produced across it to deflect the 'ammeter' in the dash. When the key is on, and the 30 bus is energized, there would be a very slight deflection to negative on the ammeter, showing the key loaded currents. AFter the engine is running, and the gen/alt is charging, it will show a slight + indication as the batt is charged.
So, there's no need for all that heavy wiring, just the wire from the batt to the loads needs to pass through the shunt which could be mounted anywhere, preferably near the batt. The current to drive the 'ammeter' remotely is in the microamps.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - Tractor Hydraulics - The Basics - by Curtis Von Fange. Hydraulics was one of the greatest inventions for helping man compound the work he can do. It’s amazing how a little floor jack can lift tons and tons of weight with just the flick of a handle. What’s even more amazing is that all the principals of hydraulic theory can be wrapped up in such a small package. This same package applies to any hydraulic system from the largest bulldozer to the oldest and smallest tractor. This short series will take a look at the basic layout of a simple hydraul
... [Read Article]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.
