Posted by r8f1k on June 28, 2018 at 07:16:07 from (73.36.20.239):
I have an Oliver 550 Serial 186 213-019. It was sitting for a spell, I took the carb off, soaked it, cleaned it up good, new gaskets, runs now, but very rich and smokes a little more than I would like. Fuel also runs out IMMEDIATELY upon shut down, which to me means the float needle is either not seating or the wrong one. I would love to rebuild the carb, but there is no tag on the carb. It is a Marvel big bowl. There are a couple stamps on the body. 1) 2G cast in under the carb inlet. 2) A31 stamped in on top of the mounting flange, normally covered by the carb to intake gasket. 3) 458/3? cast into the top portion half of the carb where the float would reside.
Soooooo.....any indication on what these numbers mean? Do they signal to a TSX number that can be used to order a kit?
Something els odd.....I have had my hand in dozens of carbs over the years, but I have never seen a plastic venturi inside one. It seems like an unstable medium......
Upload one or more videos to your post. Photo filesizes should be less than 300K and Videos, less than 2MB. Formats allowed are gif, jpg, png, ogg, mp4, mov, and avi. Be sure to use filenames without spaces or special characters, and filetypes of 3 digits lower case.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - Tractor Hydraulics - The Basics - by Curtis Von Fange. Hydraulics was one of the greatest inventions for helping man compound the work he can do. It’s amazing how a little floor jack can lift tons and tons of weight with just the flick of a handle. What’s even more amazing is that all the principals of hydraulic theory can be wrapped up in such a small package. This same package applies to any hydraulic system from the largest bulldozer to the oldest and smallest tractor. This short series will take a look at the basic layout of a simple hydraul
... [Read Article]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.
