Posted by Spook on July 29, 2018 at 06:14:10 from (104.63.94.180):
In Reply to: Fence job moving along posted by Grandpa love on July 29, 2018 at 05:41:10:
I’ve never seen a auger like that. I have a pto auger, 12 inch. I’ve never set a post that big, I figure a bigger hole let’s me be a little less accurate in position. I have set t posts with my loader, I mark the depth I am looking fo in chalk. But I’ve bent a couple of posts also. I have pretty hilly ground, so I have to post pretty close most of the time, just to get the fence to follow the ground slope. On flat sections I go 12 feet or so. I see other folks going farther, mostly livestock guys who add a electric wire to it. I like your wire unroller? I have to just kick it on the ground. I’ve got a friend that built a fence with 12 ft T posts! They sell them here because it’s hard to have a garden or orchard without some pretty extreme fencing, the deer pressure is real high. I was at a orchard, a commercial outfit, they had these huge fences, the owner told me that without those fences, it would be “ uneconomic “ to operate.
Upload one or more videos to your post. Photo filesizes should be less than 300K and Videos, less than 2MB. Formats allowed are gif, jpg, png, ogg, mp4, mov, and avi. Be sure to use filenames without spaces or special characters, and filetypes of 3 digits lower case.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - Earthmaster Project Progress Just a little update on my Earthmaster......it's back from the dead! I pulled the head, and soaked the stuck valves with mystery oil overnight, re-installed the head, and bingo, the compression returned. But alas, my carb foiled me again, it would fire a second then flood out. After numerous dead ends for a replacement carb, I went to work fixing mine.I soldered new floats on the float arm, they came from an old motorcycle carb, replaced the packing on the throttle shaft with o-rings, cut new ga
... [Read Article]
Latest Ad:
Nice Marvel Schebler DLTX 8 bronze body carburetor For 1934-1936 unstyled A tractor.Serial No.410000-42850. All restored and ready to use.
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.