Posted by CGID on July 29, 2018 at 19:11:11 from (174.27.0.169):
In Reply to: Torque-Long posted by Dean on July 29, 2018 at 15:31:17:
I enjoy your steam-train videos. I was in Two Harbors, MN recently and took a look at the DM&IR 2-8-8-4 Mallet #229 on display there; it's one-hundred & twenty-eight feet long. The tender carried 26 tons of coal and 25,000 gal. of water. The engine and tender, ready to run, weighed nearly 1,000,000 lbs. Six-thousand, two-hundred and fifty hp, 140,000 lb tractive effort. The last run was July 5, 1960. This engine and others like it hauled mile-long trains full of iron-ore to Duluth from the Masabi iron-ore range, about 80 miles NW of Duluth. "Lakers" filled with the ore at Duluth sailed the Great Lakes, taking the ore East to where the coal was. The Mallets were built specifically to haul ore for the war effort. The volume of refined steel from the ore the Mallets carried is one of the big reasons why Germany and Japan never stood a chance. Number 229 is outside, under a roof. Mallet #225 is on display outside at Proctor, MN and #227 is inside at Duluth at the Lake Superior Rail Museum. #227 is suspended a fraction of an inch above the rails. The running gear can be set in motion as when the engine was really moving.
Upload one or more videos to your post. Photo filesizes should be less than 300K and Videos, less than 2MB. Formats allowed are gif, jpg, png, ogg, mp4, mov, and avi. Be sure to use filenames without spaces or special characters, and filetypes of 3 digits lower case.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - Oliver 550 Purchaser Checklist - by Greg Sheppard. Pound for pound the 550 is better than anything I've seen. It has great power for its size and can really hunker down and lug. Classified as a 3-bottom plow depending on soil conditions. I personally don't think it can be beat for a utility tractor in the 40 HP range. They are extremely thrifty on fuel, at least my DSL is. Most drive train parts are fairly easy to get. Sheet metal is probably the hardest thing to
... [Read Article]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.
