Posted by ridgeandvalley on August 03, 2018 at 08:36:34 from (75.121.175.217):
For years, I had a neighbor who cut and baled my hay for me. I would rake, haul wagons and unload using my Ford 8n. When he could no longer do it, I bought a well used New Holland haybine and my father in law who grew up on a farm did the cutting and baling.
I now have a tractor with the capabilities of running the haybine and baler and I'm determined to be able to do the cutting and baling myself. Yesterday evening I did the cutting. Once I got speed, etc... adjusted, it went pretty well. However, it took me a lot longer to get up and running (hooking everything up; little PTO problem; etc...) than I anticipated, and I ran short of daylight before I finished cutting.
I have just a couple of strips left, and was wondering if anyone has a good tip on how to finish the field when your final strip is narrower than the 9 foot haybine. I know that running hay that is already cut through the haybine is a recipe for clogs. When others have cut for me, they've managed to finish with a clean field, having no uncut strip left in the middle.
If I have to leave a small strip in the middle of the field, it's not the end of the world, but before I head out to finish that last bit, was wondering if anyone had advice. Thanks.
Here's me running out of daylight on my first time cutting hay... kind of like the way it turned out.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - Earthmaster Project Progress Just a little update on my Earthmaster......it's back from the dead! I pulled the head, and soaked the stuck valves with mystery oil overnight, re-installed the head, and bingo, the compression returned. But alas, my carb foiled me again, it would fire a second then flood out. After numerous dead ends for a replacement carb, I went to work fixing mine.I soldered new floats on the float arm, they came from an old motorcycle carb, replaced the packing on the throttle shaft with o-rings, cut new ga
... [Read Article]
Latest Ad:
Nice Marvel Schebler DLTX 8 bronze body carburetor For 1934-1936 unstyled A tractor.Serial No.410000-42850. All restored and ready to use.
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.