Posted by Bob on August 04, 2018 at 14:04:14 from (64.255.159.199):
In Reply to: 4020 brakes sticking posted by Kory1998 on August 03, 2018 at 19:14:07:
Quoting Removed, click Modern View to see
Kory, simply loosen locknuts on brake bleed screws, then loosen bleed screws two turns.
This "dumps" brake pressure "to sump" internally.
Note whether or not the tractor acts different/the brakes release.
When done, snug down the brake bleed screws with the locknuts loose enough so the screw can bottom before the nuts get tight, then, when the screws are tight, snug down the nuts.
If you should accidentally unscrew the bleed screws too far, note that there is a steel ball in the port, that the bleed screw clamps down on.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - The Nuts and Bolts of Fasteners - Part 2 - by Curtis Von Fange. In our previous article we discussed capscrews, bolts, and nuts along with their relative hardness and thread sizes. In this segment we will finish up on our fasteners and then work with ways to keep them from loosening up in the field. Capscrews, bolts and nuts are not the only means of holding two parts together. When dealing with thinner metals like sheet tin, a long bolt and
... [Read Article]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.
