Posted by Goose on August 19, 2018 at 06:32:59 from (166.182.80.151):
In Reply to: chisle plow posted by stonerock on August 19, 2018 at 05:14:55:
I never chiseled sod, but in the mid 80's when I took over the family farm, I chiseled the entire farm. My dad had never chiseled, and he never even plowed over a couple inches deep. On plowing, he always said, "Just deep enough so it turns over". Needless to say, all of the fields were almost like sod.
That being said, that fall after harvest I rented a 1086 Farmall and a 13' chisel plow and chiseled the entire farm about 12" deep. It was tough going. Full throttle, first gear all the way, with the TA pulled back half the time. I almost hated what I put that tractor through.
By the next year, I had an 856 Farmall and an 11' chisel plow of my own and did it again. The ground loosened up, and within about three years I could roll along with that 856 in low 4th at about 4.5 mph while chiseling.
I wouldn't think doing sod would be worse than that.
Upload one or more videos to your post. Photo filesizes should be less than 300K and Videos, less than 2MB. Formats allowed are gif, jpg, png, ogg, mp4, mov, and avi. Be sure to use filenames without spaces or special characters, and filetypes of 3 digits lower case.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - The Nuts and Bolts of Fasteners - Part 2 - by Curtis Von Fange. In our previous article we discussed capscrews, bolts, and nuts along with their relative hardness and thread sizes. In this segment we will finish up on our fasteners and then work with ways to keep them from loosening up in the field. Capscrews, bolts and nuts are not the only means of holding two parts together. When dealing with thinner metals like sheet tin, a long bolt and
... [Read Article]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.
