Posted by JMOR on September 10, 2018 at 08:41:29 from (76.186.117.99):
In Reply to: Pertronix is da bomb posted by MarkB_MI on September 09, 2018 at 16:27:00:
Quoting Removed, click Modern View to seeLike almost everything in life, 'it depends'. Depends on which Pertronix unit and make/model of tractor. On some, just remove points and attach module to same mounting holes as points and run two wires thru hole already in side of distributor, whereas on others, the old breaker plate needs to be removed and replaced with a different plate, hole needs to be drilled in side of distributor or if present a vent may need removal for wires to/from module to outside distributor, magnet assembly installed on shaft, and if older Ford with front mount distributor & changing to externally mounted coil, then you find a suitable location to mount the new coil/bracket and run primary & secondary wires and install block off plate and special distributor cap. Some require removing or modifying distributor dust shield and some require adding a ballast resistor and associated wiring. Some require a change to RFI suppression spark plug and coil wires. Pertronix provides instructions with each unit.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - An Old-Time Tractor Demonstration - by Kim Pratt. Sam was born in rural Kansas in 1926. His dad was a hard-working farmer and the children worked hard everyday to help ends meet. In the rural area he grew up in, the highlight of the week was Saturday when many people took a break from their work to go to town. It was on one such Saturday in the early 1940's when Sam was 16 years old that he ended up in Dennison, Kansas to watch a demonstration of a new tractor being put on by a local dealer. It was an Allis-Chalmers tractor dealership,
... [Read Article]
Latest Ad:
Sell 1958 Hi-Altitude Massey Fergerson tractor, original condition. three point hitch pto engine, Runs well, photos available upon request
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.