Posted by davh55 on September 17, 2018 at 07:25:57 from (108.221.240.129):
In Reply to: Ford 971 Carb. issues posted by davh55 on September 17, 2018 at 05:31:58:
I cleaned the carb because it was doing the same thing before I cleaned it. It had rust and contaminants in it but seems to be clear and a good flow from the tank. I am hoping that there is still a passage or blockage in the carb that I have not found. It just seems like a major obstruction since it will not fire till after I hold my hand over the inlet of the carb to get it to fire and still have the choke just barely open. Seems to be restrictive of gas flow, however gas shows up after I hold my hand over inlet of carb. Reset float level with no change. Must be restrictive through main jet. Does any of this make since, carb cleaned up good and blown out by good air pressure. Seems to be open but not 100 percent sure.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - Oliver 550 Purchaser Checklist - by Greg Sheppard. Pound for pound the 550 is better than anything I've seen. It has great power for its size and can really hunker down and lug. Classified as a 3-bottom plow depending on soil conditions. I personally don't think it can be beat for a utility tractor in the 40 HP range. They are extremely thrifty on fuel, at least my DSL is. Most drive train parts are fairly easy to get. Sheet metal is probably the hardest thing to
... [Read Article]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.
