Posted by 37chief on September 19, 2018 at 20:15:40 from (70.181.182.143):
Last disking job of the year. I was finishing up. I stopped to close a gate. The tractor stopped. I thought I killed the motor backing up to close the disk. All I could do was walk to the truck about a block, and a half way and get my battery. The tractor started and stopped. I was on a incline. I didn't realize I was out of gas, all what was left of the gas ran to the front of the tank. It started again I pulled the clutch and it was almost level did that a few more times. It must have been starting on fumes, then the gas ran to the carb. I wasted no time loading the tractor. This was my AC Model M crawler. This doesn't sound like a big deal, but this was after noon. I was tired from bouncing around. Very rough, and hot. I'm not as young as I think I am. Anyway everything is put up for the winter. Tractor, and the 54 chevy flat bed. I will remove the insurance tomorrow, and put the truck in non operating status until next year. Stan
Upload one or more videos to your post. Photo filesizes should be less than 300K and Videos, less than 2MB. Formats allowed are gif, jpg, png, ogg, mp4, mov, and avi. Be sure to use filenames without spaces or special characters, and filetypes of 3 digits lower case.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - Tractor Hydraulics - The Basics - by Curtis Von Fange. Hydraulics was one of the greatest inventions for helping man compound the work he can do. It’s amazing how a little floor jack can lift tons and tons of weight with just the flick of a handle. What’s even more amazing is that all the principals of hydraulic theory can be wrapped up in such a small package. This same package applies to any hydraulic system from the largest bulldozer to the oldest and smallest tractor. This short series will take a look at the basic layout of a simple hydraul
... [Read Article]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.
