Posted by mt pockets on September 24, 2018 at 17:09:50 from (173.241.77.139):
In Reply to: Another auction find... posted by Dave H (MI) on September 24, 2018 at 13:40:58:
Mr. Dave, I don't reply to very many posts on here, because somebody else usually knows more than I do. However, in this case, I may be a tiny bit more knowledgeable than some . If that is a double acting cylinder, and it should be, you have to control the speed of travel by restricting the rate the discharge air leaves the cylinder. A flow control valve is the correct means of doing this. If this cylinder is pressure down and spring return, you will not be able to have the control that you need. You could put a flow control valve on the top side, it would slow the cylinder until it met resistance and then if pressure overcame resistance, It would become, as someone said, a hammer. To have complete and safe control of this machine, you would need a flow control valve on both ports of the cylinder. Flow control valves are free flow in one direction and controlled flow in the other. I hope this made sense. Steve, in Banner, Ms.
Upload one or more videos to your post. Photo filesizes should be less than 300K and Videos, less than 2MB. Formats allowed are gif, jpg, png, ogg, mp4, mov, and avi. Be sure to use filenames without spaces or special characters, and filetypes of 3 digits lower case.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - The Niagra View Mobile - Powered by a 1959 Ford Tractor - by Mark Massey. In 1959 the Niagara Frontier Transit Inc. of Buffalo, New York designed and built six Viewmobiles for the Niagara Frontier Sightseeing Inc. for use as a sightseeing ride at the Niagara Falls State Park, Niagara Falls, New York, powered by a 1959 Ford 611 Tractor.
... [Read Article]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.
