Posted by IA Roy on October 16, 2018 at 08:29:37 from (166.181.86.182):
In Reply to: Mower issue.... posted by Dave H (MI) on October 16, 2018 at 07:30:49:
I agree with the plugged jet. I try to use a copper electrical wire with insulation stripped back. Usually the jet is brass and softer than steel wire. I don't know how likely it is to damage jet with steel wire, but I don't chance it. I use a stranded copper wire and strip the insulation back as required. If it is too big, fold enough strands down to fit. I then rotate as I work it in and out. Good luck. Much easier to get it to run better than if not running at all. A lot of people like to use a gas stabilizer when putting away for the winter. I heard Briggs and Stratton fuel stabilizer works good. My son uses Seafoam. I have used Stabill with good results. I have also shut fuel off and ran the engine until carburetor was dry. I use non-ethanol regular. We have that choice in Iowa. As with a lot of subjects, there about as many solutions as there are people reading this. If you follow this forum, you will find a lot of help. Read it awhile and you will soon find common sense solutions to common problems. Great people here sharing their wisdom!
Upload one or more videos to your post. Photo filesizes should be less than 300K and Videos, less than 2MB. Formats allowed are gif, jpg, png, ogg, mp4, mov, and avi. Be sure to use filenames without spaces or special characters, and filetypes of 3 digits lower case.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - Third Brush Generators - by Chris Pratt. While I love straightening sheet metal, cleaning, and painting old tractors, I use every excuse to avoid working on the on the electrics. I find the whole process sheer mystery. I have picked up and attempted to read every auto and farm electrics book with no improvement in the situation. They all seem to start with a chapter entitled "Theory of Electricity". After a few paragraphs I usually close the book and go back to banging out dents. A good friend and I were recently discussing our tractor electrical systems when he stated "I figure it all comes back to applying Ohms Law". At this point
... [Read Article]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.
