Posted by NCWayne on October 18, 2018 at 21:41:59 from (40.142.136.241):
In Reply to: dangerous??? posted by Ellis Kinney on October 18, 2018 at 05:14:19:
They are probably the tops used to seal bottles of chemicals. I've run into them in gas tanks too, and they are a royal PITA for the very reason you state, they will get sucked over the fuel line from the tank, and cut off the flow. The way I have gotten them out is to use an air powered siphon. Hook the siphon hose to a rod of some kind to stiffen it up. With the siphon blowing the gas in a safe direction, and into a container if possible, slowly lower the vacuum tube to the piece and hold it there until it gets a suction on it great enough to pick it up. I works like a charm, and you don't have to worry as much about it trying to move away from you, as you do with mechanical fingers (been there, had that problem too)
Upload one or more videos to your post. Photo filesizes should be less than 300K and Videos, less than 2MB. Formats allowed are gif, jpg, png, ogg, mp4, mov, and avi. Be sure to use filenames without spaces or special characters, and filetypes of 3 digits lower case.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - Tractor Hydraulics - The Basics - by Curtis Von Fange. Hydraulics was one of the greatest inventions for helping man compound the work he can do. It’s amazing how a little floor jack can lift tons and tons of weight with just the flick of a handle. What’s even more amazing is that all the principals of hydraulic theory can be wrapped up in such a small package. This same package applies to any hydraulic system from the largest bulldozer to the oldest and smallest tractor. This short series will take a look at the basic layout of a simple hydraul
... [Read Article]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.
